Air cooling system evaporative condenser

Air cooling system evaporative condenser

Product introduction

The air cooler is mainly used to reduce the temperature of the machine or equipment in order to maintain its normal operation. Specific functions are as follows:Air Cooler Turbine,Industrial Air Cooler,Greenhouse Air Cooler,Cooling System Evaporative Air Cooler

1. Cooling: The air cooler blows air into the equipment through the fan to take away the heat, thus reducing the temperature of the equipment.

2. Heat dissipation: The air cooler can distribute the heat generated inside the equipment to the surrounding environment to prevent the equipment from overheating and damage.

3. Protect the equipment: The air cooler can protect the equipment from overheating and extend the life of the equipment.

4. Improve efficiency: Air cooler can improve the working efficiency of equipment, because high temperature will affect the performance of equipment.

5. Energy saving and environmental protection: compared with water coolers, air coolers do not require additional energy to operate, so they are more energy saving and environmental protection.

Product parameter

Air cooler structure: horizontal placement

Tube bundle type: "GP6X1.95-6-98.2-1.21S-17.32/DR-VIa"

Tube bundle material: SA179 K01200

Fin material: AL 1060

Fan model: G-TF15L4-Z4

Motor model: YB3-160M1-8 380V, 50HZ

Frame type: GJP6×1.95B-15/3F

Note:

1. The medium, temperature and pressure in the pipe should meet the design conditions, and overpressure and overtemperature operation is strictly prohibited;

2, the pipe pressure, temperature, should be slowly step by step, so as not to damage the equipment due to impact heat;

3, the air cooler normal operation, should first open the fan, and then to the tube bundle into the medium, stop the operation, should first stop to the tube bundle into the medium, then stop the fan;

4, the negative pressure operation of the air cooler boot, should first open the air extractor, tube to reach the specified vacuum degree and then start the fan, and then through the tube medium, shut down, according to the opposite procedure, winter operation, open the air extractor, to reach the specified vacuum degree, first through the tube medium, then start the fan, so as not to freeze the tube can not run;

5. When stopping, low pressure steam should be used to purge and clean the condensate to avoid freezing and corrosion.